Add useful StarPort attachments to your inflatable without having holes cut into the tubing.
Completely compatible with all StarPort accessories
Visit our YouTube channel for installation video by clicking HERE
Part Numbers
White: 03-4004-21 RIBPort (White base, White StarPort)
Grey: 03-4004-51 RIBPort (Grey base, Black StarPort)
What You Get:
One RIBPort (150 x 114 x 21 mm) Including StarPort
Construction Materials
StarPort: AES - (Acrylonitrile Ethylene Styrene)
RIBPort: Non-leeching PVC
Accessories: 15% glass-filled nylon
Stainless Steel Fasteners
Installation - See our Installation Video HERE
CAUTION: While the StarPort RIBPort is straightforward to install, WE STRONGLY ADVISE YOU TO USE A PROFESSIONAL RIB REPAIRER.
- Remove the StarPort and screws from the base, to avoid potential damage during installation.
- Clean the surface of both the RIB location and the base thoroughly with Methylethyl Ketone (MEK). The base should align lengthways along the side of the inflatable.
- Using a mix of Bostick 999HR (or 999HV) and DESMODOUR RFE mixed @ 5%, apply to both the RIB surface and the base. Allow to contact-dry.
- To mould the base to the curvature of your inflatable's surface, heat the base to about 80°C for NO MORE THAN 3 MINUTES in a dry oven, or by using a heat gun.
- Carefully align and apply the RIBPORT to the RIB surface, ensuring no air bubbles or dirt becomes trapped in the join, weakening the bond.
INSTALLATION: StarPort™
- Allow RIBPORT to cool, then screw the StarPort to the base.
NOTE: Use only the screws supplied (12-gauge x 20 mm (0.75 in)). Longer screws may puncture your inflatable.
;){kind=link}